Materials – Cautions for Use
714
Cleaning
Before cleaning the camera, remove the battery or the DC Coupler,
and disconnect the power plug from the electrical outlet. Then wipe
the camera with a dry, soft cloth.
•
When the camera is soiled badly, it can be cleaned by wiping the dirt off with a wrung
wet cloth, and then with a dry cloth.
•
Do not use solvents such as benzine, thinners, alcohol, kitchen cleansers, etc., as
there is a possibility that these can deform the surfaces of the camera, such as those
of the external case and the mount, or cause peeling of the coatings.
•
When using a chemical cloth, be sure to follow the accompanying instructions.
Dirt on the Image Sensor
If dirt gets inside the mount when changing lenses, depending on the
recording conditions, it may adhere to the image sensor and appear on the
recorded picture.
To prevent debris or dust adhering to internal parts of the body, avoid
changing the lens in a dusty environment and always fit the body cap or a
lens when storing the camera.
Remove any dirt on the body cap before attaching it.
Dust reduction function
The camera has a dust reduction function that will blow off the dirt and dust
that have affixed to the front of the image sensor.
If the dirt is particularly noticeable, from the [Setup] ([Others]) menu,
perform [Sensor Cleaning]. ([Sensor Cleaning]: 570)
To Next Page
Loading...
