12
Care and Cleaning of Your Microwave Oven
Cleaning the water tank
Clean with a soft sponge in water.
Remove the water tank and clean the compartment
where the water tank is inserted.
Open the water supply cap, remove the lid and pipe cap
and clean.
If the pipe cap is diffi cult to remove, wiggle from side to side. When re-fi tting, make sure that the pipe faces down (see
diagram).
The rubber seal and front of the tank can also be removed for cleaning.
Removing the front cover
1. Place the fi ngers under the front cover.
2. Pry the front cover out.
Removing/Installing the rubbers seal
Inside
(fl at)
Outside
(protruding
side)
2
1. Remove the top cover.
2. Ensure that the rubber seal is not
inside out when re-fi tting. If the seal is
not fi tted correctly the lid will not close
securely and it will leak.
Re-fi tting the front cover
1
2
1. Slide the tank into the front cover.
2. Press the bottom of the front cover
until it clicks.
NOTES:
1. Clean the water tank at least once a week to prevent build up of limescale.
2. Do not use a dishwasher to clean the water tank or parts of the water tank.
Pipe Cap
Ensure it faces downwards
1
12
(continued)
F0003BH71CP_OI_Eng_00_160121.indd sec12F0003BH71CP_OI_Eng_00_160121.indd sec12 2016/1/22 9:13:572016/1/22 9:13:57
To Next Page
Loading...
