Panasonic NV-DS15EN - Viewing the Just Recorded Scenes on the Movie Camera (Playback); Adjusting the Sound Volume

ENGLISH
Viewing the Just Recorded Scenes on
the Movie Camera (Playback)
You can play back recorded scenes right after recording.
1 ^88 the [MODE] Button until the [VCR] Lamp
O Hphte.
2 Frees the Rewind Button [«] to rewind the
tape.
•Rewind the tape to the point where the recordino
started.
•If the tape reaches the beginning, rewinding
automatically stops.
3 Press the Play Button [ ► ] to start playback.
4 To stop playback:
Press the Stop Button [ ■ ].
■ Adjusting the Sound Volume
Keep the [^SH] Dial Q pressed until the [VOLUME]
jWtcation Q appears. Then, turn the [PUSH] Dial to adjust
w'JJfne. After adjusting, press the [PUSH] Dial to make
the [VOLUME] Indication disappear.
To adjust the volume with the Remote Controller, press the
m or [W] Button to make the [VOLUME] indication appear.
You can then Increase the volume by pressing the m Button
or decrease It by pressing the [W] Button. A few seconds after
finishing the adjustment, the [VOLUME] Indication
disappears.
•The output volume from the Built-in speaker and [PHONES!
socket is adjusted.
•When using the Playback Zoom Function, it Is not possible
to adjust the sound volume.
•If a cassette recorded with copyright protection signal Is
played back, the screen becomes black.