Panasonic NV-DS15EN - Searching for the Beginning of Recorded Scenes

Searching for the Beginning of Recorded Scenes
(Seane Index Search)
♦ Press the [MODE] Button until the [VCR] Lamp lights.
•Set [SEARCH] on the (PLAYBACK FUNCTIONS]
Sub-Menu to [SCENE].
Scene index Search In Forward Direction
Press the Index Button [ ►► !] O on the Remote Controller.
Scene Index Search in Reverse Direction
Press the Index Button [144] @ on the Remote Controller.
•When you briefly press the corresponding button once, the
[S1) indication appears and the search for the next scene
marked with an index signal starts. After the Scene Index
Search has started, every time you press the button, the
indication changes successively from [S 2] to [S 9], and the
beginning of the scene corresponding to the selected
number is located. @ After reaching the desired scene,
playback starts automatically. (At a time. Scene Index
Search in forward or reverse direction is possible up to the
nindi scene marked with index signal from the present tape
position.}
•If the interval between two scene index signals is less than 1
minute, the Scene Index Search may not work correctly.
•The Scene Index Search may not work correctly for scenes
recorded near the beginning of the tape.
•If you keep the [ 144 ] or [ ►► ! ] Button pressed for more than
2 seconds, the intro Sea^ Function is activated and it
plays back the beginning of all scenes marked with an index
signa! on the cassette one after another for a few seconds
each.
(To cancel the Intro Search Function, press the Ray Button
[^] O or the Stop Button [ ■ ] 0.)