Panasonic NV-DS15EN - LCD Monitor;Finder;Lens Hood; Repeat Playback.160; Listening to the Playback Sound Via; Headphones.160

ENGLISH
■ LCD Monitor/Finder/Lens Hood
LCD Monitor
• In places where big changes In temperature occur,
condensation may form on the LCD Monitor. Wipe it with a
soft, dry doth.
•if the Movie Camera ts very cold when it is turned on, the
picture on the LCD Monitor is initially a little darker than
normally. However, as the internal temperature rises, the
LCD Monitor regains its normal brightness.
•Extremely high precision technology is employed to produce
the LCD Monitor screen featuring a total of approximately
112,000 pixels. The result is more than 99.99% effective
pixels with a mere 0.01% of the pixels inactive or always lit.
However, this is not a malfunction and does not affect the
recorded picture.
Finder
•Extremely high precision technology is employed to produce
the Finder screen featuring a total of approximately 11 3 ,000
pixels. The result is more than 99.99% active pixels, with a
mere 0.01 % of the pixels inactive or always lit. However,
this is not a malfunction and does not affect the recorded
picture.
•Do not leave the Finder or the Lens aimed at the sun. This
could seriously damage Internal parts.
•If you use a large-capadty Battery (CGP-D320: optional)
attached to the Movie Camera, viewing the picture in the
Finder from behind may not be practical. In this case, turn
up the Finder to an angle that allows comfortable viewing.
Lens Hood
•Never try to attach any conversion lens onto the front of the
Lens Hood; it does not have a threaded mount on the front.
•When you want to attach the Tele Conversion Lens (VW-
LT43UWE, optional), the Wide Conversion Lens (VW-
LW4307WE, optional) or a filter of the Filter Kit (VW-
LF43WE, optional), be sure to first remove the Lens Hood
by turning it counterclockwise. If you attach a filter of the
Filter Kit. you can attach the Lens Hood onto it.
•During recording with a filter or conversions lens attached,
the four corners of the picture may become dark {vignetting
effect), when you push the [W/T] Zoom Lever toward [WJ.
For details, please also read the operating instructions of the
accessory being used.
■ Repeat Playback
If you keep the Playback Button [ ► ) pressed for more than 5
seconds, the Movie Camera switches over to the Repeat
Playback Mode and the [R >] Indication at^ears. (To cancel
the Repeat Playback Mode, set the [OFF/ON] Switch to
[OFF].)
■ Listening to the Playback Sound via
Headphones
If you want to use headphones to listen to the playback
sound, connect them to the [PHONES] Socket on the Movie
Camera. In this case, no sound (including beep and shutter
dick sounds) is reproduced from the Movie Camera’s built-in
speaker.
Microphone Socket
If you want to perform audio dubbing via an external
microphone or audio equipment, connect it to the [MIC]
Socket. In this case, the Movie Camera’s built-in microphone
is turned off.
- 160 -