Panasonic NV-DS15EN - Supplying Power with the Battery; Charge Lamp [CHARGE]

ENGLISH
■ Supplying Power with the Battery
Before use, fully charge the Battery.
1 Have the front edge of the battery lined up with
the O mark on the side of the AC Adaptor, and
then elide It horizontally until it locks with a
click.
•If the DC Input Lead is connected to the AC Adaptor,
disconnect it as charging Is not possible otherwise.
2 Securely connect the AC Mains Lead to the AC
Adaptor and an AC mains socket.
•The [POWER] Lamp O and the [CHARGE] Lamp 0
light and charging starts.
•If the [CHARGE] Lamp does not light even though the
Battery is attached, remove the Battery and then re¬
attach it.
•When the [CHARGE] Lamp goes out, charging is
finished.
3 Remove the Battery by sliding it In the
opposite direction of Step 1 above.
•Also disconnect the AC Mains Lead.
4 Tilt the Finder upward.
5 insert the Battery Into the Battery Holder on the
Movie Camera and elide It downward until it
locks with a click.
Removing the Battery from the Movie Camera
While pressing the [PUSH] Button Q. slide the Battery
upward to remove it.
•Be careful not to drop the Battery by accident.
•Before removing the Battery, set the [OFF/ON] Switch to
[OFF],
■ Charge Lamp [CHARGE]
Lit: During charging
Off: The Battery is fully charged.
When the [CHARGE] Lamp Flashes Continuously
If the temperature of ffie Battery is extremely low or extremely
high, the [CHARGE] Lamp on the AC Adaptor flashes
continuously. It also flashes continuously when some
malfunction has occurred in the Battery or the AC Adaptor.
For details, read “Notes about the AC Adaptor" (-f 150).