Panasonic NV-DS15EN - Page 46

STDBY
REC
MRVQUJOQ
DIGITAL EFFECT
CARD SETUP
RECORDING SETUP
DISPLAY SETUP
OTHER FUNCTIONS
DEMO MODE
ENGLISH
Motfon-Sensor-Controlled Recording
In this mode, recording automatically starts when the built-in
Motion Sensor detects some movement in the picture.
1 Press the [MENU] Button.
•The [CAMERA FUNCTIONS] Main-Menu appears.
2 Turn the [PUSH] Dial to select [CAMERA
SETUP] and then press the [PUSH] Dial.
•The [CAMERA SETUP] Sub-Menu appears.
3 Turn the [PUSH] Dial to select [M.SENSOR].
4 Press the [PUSH] Dial to select [ON],
5 Press the [MENU] Button to exit the menu.
•The Motion Sensor Function Stand-by [STDBY]
Indication appears.
•Approximately 1 second after the Movie Camera’s Motion
Sensor has detected movement in the picture, recording
automatically starts. Approximately 10 seconds after
movement In the picture has stopped, recording
automatically stops and the Movie Camera is In the Motion
Sensor Stand-by Mode.
•When the Movie Camera remains in the Motion Sensor
Stand-by Mode for more than 6 minutes, the Finder turns off
to conserve power,
When the Motion Sensor again detects movement In the
picture, recording automatically restarts after approximately
4 seconds, and the Finder or LCD Monitor turns on.
Cancelling the Motion Sensor Function During
Stand-by
Set IM.SENSOR] on the [CAMERA SETUP] Sub-Menu to
[OFF].
Cancelling the Motion Sensor Function During Rscording
Press the Recording Start/Stop Button for 2 seconds.