Panasonic NV-DS15EN - Page 93

ENGLISH
Before Requesting Service (Problems
& Soiutions)
Power Supply
PI: The Movie Camera does not turn on.
Si: is the Battery or the AC Adaptor connected correctly'?
Confirm the connection. 16 )
P2: The Movie Camera has turned off automatically.
S2: If you leave the Movie Camera in the Recording Pause
Mode for more than 6 minutes, it automaticaliy
switches off to protect the tape and to conserve batterv
power. 44)
P3: The Movie Camera quickly turns off.
S3-1: Is the Battery discharged? When the Remaining
Battery Power Indication is flashing or the f r »
Indication is displayed, the Battery is discharged
Charge the Battery or attach a fully charged Batterv
(•4 18,174)
S3-2: Has condensation formed? If the Movie Camera is
brought from a cold to a warm place, condensation
may form Inside. In this case, the Movie Camera
automatically switches off and no operation can be
performed except taking out the cassette. Wait until the
Condensation Indication disappears. (4 152 )
P4i The Movie Camera Is turned on but no functions
operate.
S4; Press the [RESET] Button. If this does not solve the
problem, turn the power off for approximately one
minute before turning the power on again.
(If the above operation is performed when the
(ACCESS) Lamp of the Card Slot is lighting for
NV*DS25, the data of the MuitiMediaCard may be
damaged.)
Battery
PI: The Battery discharges quickly.
SI-1: Is the Battery fully charged? Charge ft with the AC
Adaptor. (4 16)
S1-2: Are you using the Battery in a place where the
temperature is very low? The ambient temperature
greatly influences the Battery's performance. Its
operation time becomes shorter in a cold place.
(4 168)
Sl-3. Has the Battery reached the end of its service life? The
service life of the Battery is limited. It depends on the
way the Battery is used, but when the operation time
even after proper charging is too short for normal use
the service life of the Battery has reached its end
P2: The Battery cannot be charged.
S2: If the DC Input Lead is connected to the AC Adaptor,
charging is not possible. Disconnect the DC Incut
Lead.