SYMPTOM
CAUSE
REMEDY
CHECKED
Remote controller will not work correctly
Ensure that remote controller is being pointed at VTR
and that transmitter beam is not obstructed.
Use remote controller within 7 m of VTR. If this range
is not possible, replace batteries.
Remote controller
does not operate
correctly.
Remote controller transmitter
beam is not reaching VTR.
Distance is too far.
Batteries are exhausted.
Replace batteries. Note precaution for replacement
on page 13.
Batteries are incorrectly fitted
with (+/—) reversed.
Fit batteries correctly as shown on page 13.
Bar code reading is
not possible.
Remote controller is in power
saving condition.
Press
SCANNER ON/OFF
to turn it on again.
Practice tracing the bar code from left to right. Each
bar code should take around half a second to trace. A
beep indicates bar code is read correctly.
Bar code is not traced
correctly.
Bar code sensor cap is
blocked.
Remove sensor cap and clean as shown on page 26.
VTR is operating.
Timer record memory is full.
Stop VTR.
Cancel timer programme to enter a new timer
programme or wait until one timer recording has
taken place.
Bar code data
cannot be
transmitted to VTR.
Bar code reading is not
followed by a repeated bleep.
Read bar code again.
32
To Next Page
Loading...
