Power indicator
Power indicator informs you of the status of the power.
When the
TEMP indicator is ashing, the power
indicator will turn red, and you cannot switch on the
power.
Power indicator
Indicator status Status
No illumination or ashing MAIN POWER is switched off.
Red
Lit MAIN POWER is switched on and the projector is in standby mode.
Flashing
MAIN POWER is switched on (standby mode) and the POWER ON LINK is set to
ON.
The power consumption is not much different when it is lit.
•
(See “VIERA Link Connection” on page 45)
Green
Flashing The power button is switched on and the projector is getting ready to project.
Lit Projecting.
Orange
Lit The power button is switched off and the projector is cooling the lamp.
Flashing
The power button is switched on again when cooling the lamp and recovering to
projection mode. Recovery may take a while.
NOTE:
See “TEMP indicator” in “TEMP and LAMP Indicators” of the operating instructions. •
While the projector is cooling the lamp, do not switch • MAIN POWER off or unplug the mains lead.
The electric consumption in standby mode is 0.08 W. •
To Next Page
Loading...
