Panasonic PT-AE4000E

PICTURE menu
E
NGLISH - 21
COLOUR TEMPERATURE
You can adjust the white balance of the projected image.
Less
bluish
More
bluish
Setting range: −6 to +6
DYNAMIC IRIS
You can switch automatic adjustment of the lamp and
the lens iris on/off.
ON: Automatic adjustment
OFF: No adjustment
WAVEFORM MONITOR
You can monitor whether or not the luminance level
of the input signal is in the recommended range by
displaying it in the waveform monitor. If the waveform
is not in the recommended range, adjust it for the
best quality. See “Adjusting the signal condition with a
waveform” on page 14.
OFF
FULL SCAN(Y)
FULL SCAN(R)
FULL SCAN(G)
FULL SCAN(B)
SINGLE LINE SCAN(Y)
SINGLE LINE SCAN(R)
SINGLE LINE SCAN(G)
SINGLE LINE SCAN(B)
MONITOR POSITION
UPPER LEFT
AUTO ADJUST
Press ▲ ▼ to move to the required waveform 1.
style.
Press the2. ENTER button to select.
The WAVEFORM MONITOR will be displayed.
NOTE:
When the • WAVEFORM MONITOR is set to OFF, the
AUTO ADJUST is not displayed.
The waveform of the • WAVEFORM MONITOR will
not be displayed correctly with a noisy equipment or
source.
The • WAVEFORM MONITOR adjusts the signal level
based on the reference signal which consists of 0 %
and 100 %. The over scanned reference signal which
runs off the edge of the screen, below 0 % or over
100 % signal level will not be adjusted correctly.
MONITOR POSITION
J
When the FULL SCAN is selected, press ▲ ▼ ◄
► to adjust the position of the monitor.
See “Adjusting the signal condition with a waveform”
on page 14.
AUTO ADJUST
J
You can switch on/off the automatic adjustment
system in each item.
BLACK LEVEL ADJUST
Adjust the black level of luminance (Y) to 0 %.
ON
WHITE LEVEL ADJUST
Adjust the white level of luminance (Y) to
100 %.
ON
RGB ADJUST (BLACK)
Adjust the black level of colours (R/G/B) to 0 %.
OFF
RGB ADJUST (WHITE)
Adjust the white level of colours (R/G/B) to
100 %.
OFF
Press ▲ ▼ and select the required item.1.
Press ◄ ► and switch on/off.2.
Press ▲ ▼ and select 3. START AUTO ADJUST
and press the ENTER button.
The conrmation screen will be displayed.
Press ◄ ► and select 4. OK.
Press the 5. ENTER button.
Adjustment example
J
Project a commercial test signal for picture
adjustment on the screen and press the
WAVEFORM MONITOR button.
100%
50%
0%
100%
5
0%
0%
100%
5
0
%
0%
ENTER
ENTER
Adjust to 100 %
Adjust to 100 %
Monitor position
Monitor position
Signal levelSignal level
Adjust to 0 %
Adjust to 0 %
Image
displayable area
Image
displayable area
With COMPUTER (except HD) or
HDMI (Expand)