Panasonic PT-AE4000E

PICTURE menu
E
NGLISH - 23
Press the 3. MENU button to display the PICTURE
menu on the right.
-
+
-
+
-
+
-
+
-
+
-
+
PICTURE MODE
CONTRAST
BRIGHTNESS
COLOUR
TINT
SHARPNESS
COLOUR TEMPERATURE
DYNAMIC IRIS
WAVEFORM MONITOR
SPLIT ADJUST
ADVANCED MENU
MEMORY SAVE
MEMORY LOAD
MEMORY EDIT
NORMAL
ON
0
0
0
0
0
0
PICTURE
POSITION
LANGUAGE
LENS CONTROL
FUNCTION BUTTON
VIERA LINK MENU
OPTION
ENTER
RETURN
SELECT
PT-AE4000E
MOVE AREA GO TO SPLIT ADJUSTENTERGO TO FREEZE SCREENRETURN
Adjust the required 4. PICTURE menu items.
Only the highlighted menu items are adjustable.
Sub-menu items vary according to the selected input
signal. See “Menu list” on page 17.
Press the 5. MENU or RETURN button several times
to escape from the menu.
Press the 6. ENTER button.
The conrmation screen will be displayed. Select
YES to nish the adjustment.
Press the 7. ENTER button.
Press the ENTER button again to return to the
AREA SELECT.
Press the RETURN button to escape from the SPLIT
ADJUST mode.
ADVANCED MENU
You can perform more detailed image adjustment
manually.
J
GAMMA
You can make detailed adjustments to the light
intensity of each input signal level by using the
ADVANCED mode or using the SIMPLE mode to
adjust at 3 levels (high, mid, low).
NOTE:
You can only adjust the • GAMMA settings through
either the ADVANCED or SIMPLE mode.
Both settings cannot be used at the same time.
Select GAMMA ADJUSTMENT in ADVANCED
MENU, and press ◄ ► or the ENTER button.
GAMMA ADJUSTMENT
CONTRAST R
CONTRAST G
CONTRAST B
BRIGHTNESS R
BRIGHTNESS G
BRIGHTNESS B
NR
ADVANCED MENU
ADVANCED
0
0
0
0
0
0
0
Setting the GAMMA with the
Q
ADVANCED mode
The 1. GAMMA ADJUSTMENT menu will be
displayed and press ◄ ► to select ADVANCED.
ADJUSTMENT MODE
GAMMA HIGH
GAMMA MID
GAMMA LOW
POINT
Y ADJUST
R ADJUST
G ADJUST
B ADJUST
INITIALIZE
ADVANCED
5
GAMMA ADJUSTMENT
RETURN
SELECT
To open the 2. Y ADJUST menu, press ▲ ▼ to
select Y ADJUST and then press the ENTER
button.
In the graph below
Maximum 9 points are adjustable.
The point counts from lower input signal, 1 to 9.
CHANGE MODE
RESET
RETURN
CHANGE POINT
OUTPUT ADJ.
INTPUT ADJ.
Y ADJUST
POINTINPUT
0% 50%
50%0
5
100%
INPUT
OUTPUT
OUTPUT
Presents selected point
Information about the present selected point.
The factory default setting:
POINT [5] INPUT [50 %] OUTPUT [0]
POINT
Display the present selected point number.
Your selected point is indicated in yellow on
the graph.
(The factory default setting: point 5)
INPUT
Display the input level of the present
selected point.
Setting range: from 1 to 99 % in increments
of 1 %
(The factory default setting: 10, 20, 30, 40,
50, 60, 70, 80, 90 %)
OUTPUT
Display the output level of the present
selected point.
Adjustable range depends on the input level.
(The factory default setting: 0)