Projecting an image
Selecting the input signal
Switch on the connected devices.1.
Press the play button of the required device.
Press the 2. INPUT SELECT button to select the
required input method if needed. See “Switching
the input signal” on page 15.
The image will be projected on the screen.
NOTE:
AUTO SEARCH • is ON as default and the signal from
the connected devices is detected automatically. See
“AUTO SEARCH” on page 39.
Positioning the image
Adjust the projected image with the lens shift dials. 1.
See “Lens shift and positioning” on page 6.
Adjust the angle of the projector.2.
Screw the front leg adjusters up/down and adjust the
angle vertically.
See “Front leg adjusters and throwing angle” on
page 5.
Adjust the focus and the projected image size.3.
Press +/− of the
FOCUS and ZOOM buttons to
adjust.
Press the
LENS button to adjust the focus and zoom
by the remote control. See “LENS CONTROL” on
page 35.
NOTE:
Do not touch the air exhaust port as this may cause •
burns or injury.
If keystone distortion occurs, see “KEYSTONE” on •
page 34.
If you adjust the focus, you may need to adjust the size •
of the image by pressing the ZOOM button again.
To Next Page
Loading...
