Panasonic PT-FX400U

Basic operations using the remote control
ENGLISH -
33
Basic Operation
Adjusting the display position
automatically
This function allows you to automatically adjust
[SHIFT], [DOT CLOCK] and [CLOCK PHASE] during
signal input from a computer.
button
Press the <AUTO SETUP> button on the
remote control.
Note
Only [SHIFT] is automatically adjusted during DVI digital
z
and HDMI signal input.
A search for input is made when there is no signal. (When
z
[SIGNALSEARCH] is set to [ON]) (
Æ
page 53)
When signals exceeding DOT CLOCK 162 MHz are
z
input, [DOT CLOCK] and [CLOCK PHASE] cannot be
automatically set. (
Æ
page 43)
When “AUTO SETUP" is used on images with blurred
z
edges or dark images, operation may automatically stop.
Should this happen, switch to a different image and press
the <AUTO SETUP> button again.
Using the function buttons
Three function buttons (<FUNC 1> to <FUNC 3>) on
the remote control can be assigned to any frequent
operations. They can be used as a useful shortcut
button.
buttons
Press any of the <FUNC 1> to <FUNC 1 )
3> buttons on the remote control.
Note
For details, see “FUNCTION BUTTON” of “PROJECTOR
z
SETUP”. (
Æ
page 60)
Using ECO button
Displays [ECO MANAGEMENT] menu.
button
Press the <ECO> button on the remote
control.
Note
For details, see “ECO MANAGEMENT” of “PROJECTOR
z
SETUP". (
Æ
page 59)
Resetting to the factory
default
Use the DEFAULT button to return a submenu setting
or adjustment value to its factory default.
button
Press <DEFAULT> button on the remote
control
Note
For details, see “Resetting to the factory default” in
z
“Menu Navigation” under “Navigating through the menu”.
(
Æ
page 35)