Panasonic PT-FX400U

SECURITY menu
66
- ENGLISH
Settings
CONTROL DEVICE SETUP
You can enable/disable the button operations of the
Control panel of the main unit and remote cotrol.
Press ▲▼ to select [CONTROL 1 )
DEVICE SETUP].
Press the <ENTER> button.2 )
The [CONTROL DEVICE SETUP] screen will
z
be displayed.
Press ▲▼ to select items and ◄► to 3 )
switch settings.
If you choose [DISABLE], select [OK] and press
z
<ENTER> button in the conrmation screen
that appears.
J
CONTROL PANEL
Restriction of control from the main unit controls
can be set.
Each press of the button switches the settings
z
as shown below.
ENABLE DISABLE
ENABLE
Enables control from the main unit
controls.
DISABLE
Disables control from the main unit
controls.
J
REMOTE CONTROLLER
Restriction of control from the remote control can
be set.
Each press of the button switches the settings
z
as shown below.
ENABLE DISABLE
ENABLE
Enables control from the remote
control.
DISABLE
Disables control from the remote
control.
Note
If you [DISABLE] both of the [CONTROL PANEL] and
z
[REMOTE CONTROLLER] buttons, you cannot turn the
power [OFF] (return to the standby mode).
Cancelling a [DISABLE] setting:
Press the <ENTER> button while holding down
the <MENU> button for 2 seconds on the main
unit controls to reset a [DISABLE] setting on the
“CONTROL PANEL” to [ENABLE].
Use the projector to change [REMOTE
CONTROLLER] settings.