Panasonic PT-FX400U

PICTURE menu
ENGLISH -
41
Settings
NOISE REDUCTION
[Only for S-VIDEO and VIDEO signal input]
This can be used to adjust pictures if they contain
interference as a result of poor quality of the input
signal.
Press ▲▼ to select [NOISE 1 )
REDUCTION].
Press ◄► or the <ENTER> button.2 )
The [NOISE REDUCTION] screen will be
z
displayed.
Press ◄► to switch [NOISE 3 )
REDUCTION].
The setting will change as follows each time
z
you press the button.
ON OFF
ON Enables noise reduction
OFF Disables noise reduction
Attention
If [NOISE REDUCTION] is set active when the selected
z
input signal has less noise, applying noise reduction may
affect the image quality. If so, set to [OFF].
TV-SYSTEM
[Only for S-VIDEO and VIDEO signal input]
Select color system to suit input signal.
Press ▲▼ to select [TV-SYSTEM].1 )
Press ◄► or the <ENTER> button.2 )
The [TV-SYSTEM] screen appears.
z
Press ◄► to select system.3 )
Each press of the button switches the settings
z
as shown below.
AUTO NTSC NTSC4.43
PAL
SECAM PAL-N PAL-M
Attention
[AUTO] mode is selected by default.
z
When the projector is not working properly in [AUTO]
z
mode, change the setting according to each SYSTEM
SELECTOR type.
Note
[AUTO] automatically selects from NTSC, NTSC4.43,
z
PAL, PAL-M, PAL-N, SECAM, and PAL60.
RGB/YP
B
P
R
[Only for RGB/YP
B
P
R
signals input]
Set this function to [AUTO] for normal operation.
When [AUTO] does not provide a normal picture,
select [RGB] or [YP
B
P
R
] depending on signal input.
This function is available only with the following signal
inputs. (VGA60, 525i(480i), 625i(576i), 525p(480p),
625p(576p), 1125(1080)/60i, 1125(1080)/50i,
1125(1080)/60p, 1125(1080)/50p, 1125(1080)/24p,
750(720)/60p, 750(720)/50p)
Use the steps below to select signal input to the
COMPUTER, DVI-I, and HDMI terminals.
Press ▲▼ to select [RGB/YP1 )
B
P
R
].
Press ◄► or the <ENTER> button.2 )
The [RGB/YP
z
B
P
R
] screen appears.
Press ◄► to select.3 )
Each press of the button switches the settings
z
as shown below.
AUTO RGB YP
B
P
R
AUTO
A synch signal automatically selects RGB
or YP
B
P
R
signal
RGB Select for RGB signal input
YP
B
P
R
Select for YP
B
P
R
signal input
When the DVI (digital) signal is input, you can not
select [AUTO]. You can select only when [RGB] or
[YP
B
P
R
] is input.