Panasonic PT-RZ470 Series

INF - 9
3. "DISPLAY OPTION" menu
The following one item is added.
・CUT OFF
Red(R), Green(G), Blue(B) color component is selected and display or non-display set.
4. "PROJECTOR SETUP" menu
1) The selections below are added on "Emulate" in the sub menu "RS-232C" setting.
-MODE_HI （Other company products） -MODE_MI （Other company products）
-MODE_NE （Other company products） -MODE_SO （Other company products）
-MODE_EP （Other company products） -MODE_IN （Other company products）
-MODE_SA （Other company products）
-OTHER （Other company products）
-MODE_SH （Other company products）
2) The following items are added on "STATUS" sub menu (page 1/3).
・OPTICS MODULE TEMP.
・EMULATE-VERSION
3) The following items are added on "STATUS" sub menu (page 2/3).
・
FPGA VERSION (software version)
・
BALLAST VERSION (software version)
・
DIGITAL LINK VERSION (software version)
4) This page will be added on "STATUS" sub menu (page 3/3).
・
Displays the temperature of the various parts, and
the number of fan rotation etc.
5. "TEST PATTERN" menu
・
The following test patterns are added.
"Flag", "Reverse flag", "Whole red", "Whole green", "Whole blue", "Whole cyan", "Whole magenta",
"Whole yellow", "Convergence (RGB bar)” patterns.