ADJ - 8
1. 6. Drive Current, White balance, Color luminance adjustment
1. 6. 1. Necessary equipments
1. Dark room : To measure the light level/color points.
2. Screens : Appros 40 inch diagonal size white mat type screen.
3. Luminqance/Color meter : recommend Konica-Minolta CL-200.
4. Serial cable from Luminance/Color meter to PC : In case using CL-200, T-A11 is the type number.
5. PC : To make communication between Luminance/Color meter to the projector.
6. Serial cable : RS-232C streight with D-sub9 male/female type for communicationg between PC to projector.
7. Service tool software : SSI_Service_Tool （Please download from service web page)
1. 6. 2. Preparation
1. Set the projector lens at center position with wide end zoom.
2. Set the throw distance at 1.25～1.30m （approx 40inch）
3. Connect serial cable between projector and PC.
4. Connect Serial cable (T-A11) between Luminance/Color meter（CL-200A）.
1. 6. 3. Start up the equipments
1. Power on the projector.
2. Start-up the service tool software "SSI_Service_Tool" on the PC.
3. Communicate automatically, when start the SSI_Service_Tool.
●
"Model Info" will be displayed if it succeeds in communication.
This process shows how to adjust each light source device (LED-R, LED-B, LD, Phosphor wheel） driving level.
Please follow these process when these devices are replaced.
Dark room
Serial cable (T-A11)
1.25～1.30m
Table
RS-232 straight
Luminance/Color meter
Screen
PJ
PC
To Next Page
Loading...
