Setting
ENGLISH -
41
Settings
Remote ID
When you use the system with multiple projectors,
you can operate all the projectors simultaneously or
each projector individually using single remote control,
if a unique ID number is assigned to each projector.
There are 7 different remote control IDs: [All],
[ID1]~[ID6].
Press ▲▼ to select [Remote ID].1 )
Press ► to display the setting dialog 2 )
box.
Press ◄► to select the desired item.3 )
Attention
When operating the projector under [All] code, you can
z
operate several projectors at the same time.
If you want to control the projector with a specied
z
remote control ID, make sure the remote control ID on
the remote control t to the remote control ID on the
projector. (
Æ
page 20)
Startup Logo
Set this function to display the Panasonic logo when
the projector is turning on.
Press ▲▼ to select [Startup Logo].1 )
Press ► to display the setting dialog 2 )
box.
Press ◄► to switch [On]/[Off].3 )
On
The logo will display when the
projector is turning on.
Off
The logo will not display when the
projector is turning on.
UART Mode
Use this function to select RS-232 or LAN function.
Press ▲▼ to select [UART Mode].1 )
Press ► to display the setting dialog 2 )
box.
Press ◄► to select the desired item.3 )
LAN
Control the projector via <LAN>
terminal.
RS-232
Control the projector via <SERIAL
IN> terminal.
Note
When [RS-232] is selected, [LAN(Standby)] and the
z
items of [LAN] are disable.
LAN (Standby)
Use this function to use network function when the
projector is in standby mode.
Press ▲▼ to select [LAN (Standby)].1 )
Press ► to display the setting dialog 2 )
box.
Press ◄► to switch [On]/[Off].3 )
On
LAN function is available when in
standby mode.
Off
LAN function is unavailable when
in standby mode.
Reset
Return all data that has been set in the [Setting] menu
to the factory defaults.
Press ▲▼ to select [Reset].1 )
Press ► to display the setting dialog 2 )
box.
Press ▲▼ to select [Yes].3 )
Press ► to execute.4 )
Note
Lamp used time has been set by user in the [Options]
z
menu will not be reset.
To Next Page
Loading...
