Panasonic PT-TW340 - Page 22

22 - ENGLISH
Attention
f When a LAN cable is directly connected to the projector, the network connection must be made indoors.
1 <VARIABLE AUDIO OUT> terminal
This is the terminal to output audio signal input to the
projector.
2 <VIDEO IN> terminal
This is the terminal to input video signals.
3 <COMPUTER 1 IN> terminal
This is the terminal to input RGB, YP
B
P
R
/YC
B
C
R
or
S-video signals.
4 <COMPUTER 2 IN/ 1 OUT> terminal
This is the terminal to input RGB signals or output the
RGB
signals to external monitor.
5 <HDMI IN> terminal
This is the terminal to input HDMI signals.
6 <LAN> terminal
This is the LAN terminal to connect to the network.
7 <USB B (DISPLAY)> terminal
This terminal is used to connect the projector to the
computer with a USB cable when you want to use the
USB Display function.
8 <USB A (VIEWER)> terminal
When using the Memory Viewer function, insert the USB
memory directly to this terminal.
9 <AUDIO IN 1> terminal
This is the terminal to input computer audio signals.
In addition, if you have set [HDMI setup] → [Sound]
to [Computer], it outputs the analog audio of the input
signal which is input to <AUDIO IN 1> terminal when the
HDMI input source is selected.
10 <AUDIO IN 2 (L/R)> terminal
This is the terminal to input Video, S-video and YC
B
C
R
/
YP
B
P
R
audio signals.
There are a left (L) terminal and a right (R) terminal.
11 <SERIAL IN> terminal
This is the RS-232C compatible terminal to externally
control the projector by connecting a computer.
Rear terminals
r Only for PT-TW340, PT-TW250, PT-TX400 and PT-TX310
1
2 3
4
5 6 7
8
9
10
11
Chapter 1 Preparation - About your projector