4) Press qw to switch [IN STANDBY MODE].
f The items will switch each time you press the button.
[OFF]
Disables audio output in the standby mode.
[ON]
Enables audio output in the standby mode when [STANDBY MODE] is set to [NORMAL]. At this
time, press the <VOL - > button / <VOL +> button on the remote control or qw buttons on the
control panel to adjust the volume.
Note
f Audio cannot be output during standby when [ECO MANAGEMENT] → [STANDBY MODE] is set to [ECO] or [NETWORK]
(Æpage 77).
Setting audio input selection
Choose the audio input terminal for each input signal.
1) Press as to select [AUDIO SETTING].
2) Press the <ENTER> button.
f The [AUDIO SETTING] screen is displayed.
3) Press as to select one item of [AUDIO IN SELECT].
[COMPUTER1]
Set the audio output when [COMPUTER1] input is selected.
[COMPUTER2]
Set the audio output when [COMPUTER2] input is selected.
[VIDEO]
Set the audio output when [VIDEO] input is selected.
[S-VIDEO]
Set the audio output when [S-VIDEO] input is selected.
[HDMI]
Set the audio output when [HDMI] input is selected.
[NETWORK/USB]
Set the audio output when [NETWORK/USB] input is selected.
4) Press qw to switch the item.
f The sub items will switch each time you press the button.
[COMPUTER1]
Select one item among [AUDIO IN 1], [AUDIO IN 2] or [AUDIO IN 3].
[COMPUTER2]
Select one item among [AUDIO IN 1], [AUDIO IN 2] or [AUDIO IN 3].
[VIDEO]
Select one item among [AUDIO IN 1], [AUDIO IN 2] or [AUDIO IN 3].
[S-VIDEO]
Select one item among [AUDIO IN 1], [AUDIO IN 2] or [AUDIO IN 3].
[HDMI]
Select one item among [HDMI AUDIO IN], [AUDIO IN 1], [AUDIO IN 2] or [AUDIO IN 3].
[NETWORK/USB]
Select one item among [NETWORK/USB AUDIO IN], [AUDIO IN 1], [AUDIO IN 2] or [AUDIO IN 3].
Note
f When [MIC] is set to [ON], [AUDIO IN 2] cannot be selected.
f Even if [AUDIO IN 2] is selected, it will change to [AUDIO IN 1] automatically when [MIC] is set to [ON].
Using MIC function
1) Press as to select [AUDIO SETTING].
2) Press the <ENTER> button.
f The [AUDIO SETTING] screen is displayed.
3) Press as to select [MIC].
4) Press qw to switch the item.
f The items will switch each time you press the button.
[ON]
<AUDIO IN 2> terminal switches to MIC input.
[OFF]
MIC is disabled.
5) Press as to select [MIC GAIN].
6) Press qw to adjust the level.
Operation Adjustment Range
Press the w button.
Turns up the MIC mixing gain.
0 ~ 63
Press the q button.
Turns down the MIC mixing gain.
Note
f When [OFF] is selected in MIC function, the MIC GAIN function is not available.
f If the MIC function is set to [ON] when connecting audio signals to the <AUDIO IN 2 (MIC IN)> terminal, loud sound may be
output suddenly depending on the setting value of [MIC GAIN].
ENGLISH
-
79
Chapter 4 Settings - [PROJECTOR SETUP] menu
To Next Page
Loading...
