2 3
1
5
4
r Top
r Bottom
: Projection direction
1 Vertical lens shift dial
Adjusts the projecting position in the vertical direction (vertical
shift).
2 Control panel and Indicators (
Æ
page 21)
3 Lamp cover
The luminous lamp is inside.
4 Air exhaust port
5 Burglar hook port
Attaches a burglar prevention cable, etc.
Attention
f Do not block the ventilation ports (intake and exhaust) of the projector.
r Control panel and Indicators
8
9
10
1
2
3
4
6
5
7
1 Power button <v/b> (v Standby / b Power on)
Sets the projector to the state where the projector is switched
off (standby mode). Also starts projection when the power is
switched off (standby mode).
2 Power indicator <ON(G)/STANDBY(R)>
Displays the status of the power.
3 Lamp indicator <LAMP>
Displays the status of the luminous lamp.
4 Temperature indicator <TEMP>
Displays the status of the internal temperature.
5 Ambient luminance sensor (
Æ
page 56)
6 <MENU> button
Displays or hides the main menu. (
Æ
page 50)
When the sub menu is displayed, pressing it will return to the
previous screen.
7 <ENTER> button
Determines and executes an item in the menu screen.
8 <INPUT SELECT> button
Switches the input signal to project. (
Æ
page 41)
9 asqw buttons
Used to select the menu screen items, switch the setting or
adjust the level.
Also used to enter a password in the [SECURITY] menu or enter
characters.
Used to automatically adjust with auto setup function while
projecting the image. (
Æ
page 46)
ENGLISH - 21
Chapter 1 Preparation - About your projector
To Next Page
Loading...
