Panasonic PT-VW540

5) Press the <ENTER> button.
f The [WHITE LEVEL] screen is displayed.
f By setting [AUTO TESTPATTERN] to [ON], the test pattern for white is displayed.
6) Press as to select [RED], [GREEN] or [BLUE].
7) Press qw to adjust.
f The adjustment value changes between 128 and 512.
8) Press the <MENU> button.
f The [6COLORS] screen is displayed.
9) Press as to select [RGBCMY].
10) Press the <ENTER> button.
f The [RGBCMY] screen is displayed.
11) Press as to select [RED], [GREEN], [BLUE], [CYAN], [MAGENTA], [YELLOW].
12) Press the <ENTER> button.
f The [RGBCMY:RED], [RGBCMY:GREEN], [RGBCMY:BLUE], [RGBCMY:CYAN], [RGBCMY:MAGENTA]
or [RGBCMY:YELLOW] screen is displayed.
f By setting [AUTO TESTPATTERN] to [ON], the test pattern for the selected color is displayed.
13) Press as to select [RED], [GREEN] or [BLUE].
14) Press qw to adjust.
f The adjustment value changes between 0
*1
and 512
*1
.
*1 The lower and upper limits vary depending on the adjusting color.
Note
f When adjusting [6COLORS], follow the order from [WHITE LEVEL] to [RGBCMY]. If [WHITE LEVEL] is adjusted after [RGBCMY], you need
to adjust the [RGBCMY] again.
f Operation when correcting the adjustment color
When correction color red is changed: Red is added to or subtracted from the adjustment color.
When correction color green is changed: Green is added to or subtracted from the adjustment color.
When correction color blue is changed: Blue is added to or subtracted from the adjustment color.
f This adjustment should be carried out by a person who is familiar with the projector or by a service person because a high level of skill is
required to make a successful adjustment.
f Pressing the <DEFAULT> button on the remote control will restore the factory default settings for all items.
f When [COLOR ADJUSTMENT] is set to [6COLORS], [COLOR CORRECTION] is xed to [OFF] and the [PICTURE] menu → [COLOR
TEMPERATURE] is xed to [DEFAULT].
[COLOR CORRECTION]
Colors can be adjusted and registered for each input signal format.
1) Press as to select [COLOR CORRECTION].
2) Press qw to switch the item.
f The items will switch each time you press the button.
[OFF]
Standard setting
[USER]
For each of the following three signal formats: VIDEO, RGB, and YP
B
P
R
/YC
B
C
R
, six colors of red,
green, blue, cyan, magenta, and yellow can be adjusted and registered. Press the <ENTER> button
to set the details. Adjustment is possible within the range of -32 - +32.
Note
f When [COLOR ADJUSTMENT] is set to other than [OFF], [COLOR CORRECTION] is xed to [OFF] and cannot be set.
[ON-SCREEN DISPLAY]
Set the on-screen display.
68 - ENGLISH
Chapter 4 Settings - [DISPLAY OPTION] menu