Setting the audio output during standby
1) Press as to select [AUDIO SETTING].
2) Press the <ENTER> button.
f The [AUDIO SETTING] screen is displayed.
3) Press as to select [IN STANDBY MODE].
4) Press qw to switch the item.
f The items will switch each time you press the button.
[OFF]
Disables audio output in the standby mode.
[ON]
Enables audio output in the standby mode.
Note
f When the [PROJECTOR SETUP] menu → [ECO MANAGEMENT] → [STANDBY MODE] is set to [ECO], audio cannot be output during
standby.
f When [IN STANDBY MODE] is set to [ON], you can adjust the volume with the <VOL-> button / <VOL+> button on the remote control or the
qw buttons on the control panel during standby.
Setting the audio input from the connected device
Choose the audio input terminal for each input signal.
1) Press as to select [AUDIO SETTING].
2) Press the <ENTER> button.
f The [AUDIO SETTING] screen is displayed.
3) Press as to select the items of [AUDIO IN SELECT] to set.
[COMPUTER1]
Set the audio output for COMPUTER1 input.
[COMPUTER2]
Set the audio output for COMPUTER2 input.
[VIDEO]
Set the audio output for VIDEO input.
[HDMI1]
Set the audio output for HDMI1 input.
[HDMI2]
Set the audio output for HDMI2 input.
4) Press qw to switch the item.
f The sub items will switch each time you press the button.
[AUDIO IN 1]
Audio connected to the <AUDIO IN 1> terminal is output during projection of image from the set input
terminal.
[AUDIO IN 2]
Audio connected to the <AUDIO IN 2> terminal is output during projection of image from the set input
terminal.
[AUDIO IN 3]
Audio connected to the <AUDIO IN 3> terminal is output during projection of image from the set input
terminal.
[HDMI1 AUDIO IN]
*1
Audio input to HDMI1 is output.
[HDMI2 AUDIO IN]
*2
Audio input to HDMI2 is output.
*1 Only for HDMI1 input.
*2 Only for HDMI2 input.
[TEST PATTERN]
Displays the test pattern built-in to the projector.
The settings such as [CONTRAST] or [BRIGHTNESS] that can be set from the [PICTURE] menu will not be
reected in the test pattern. Make sure to perform various adjustments with input signals displayed.
1) Press as to select [TEST PATTERN].
2) Press the <ENTER> button.
f The ALL WHITE test pattern is displayed.
3) Press qw to switch the test pattern.
f The test pattern will switch each time you press the button.
80 - ENGLISH
Chapter 4 Settings - [PROJECTOR SETUP] menu
To Next Page
Loading...
