Panasonic S-200PE1E8A - Detailed Setting Items

7
7
Item code Item Description
10 Unittype
SetwhentheindoorunitEEPROMmemoryisreplacedduringservicing.
11 Indoorunitcapacity
12
System(outdoorunit)
address
Thesearenotsetatthetimeofshippingfromthefactory.
Thesemustbesetafterinstallationifautomaticaddresssettingisnot
performed.
13 Indoorunitaddress
14 Groupaddress
17
Coolingintake
temperatureshift
Shiftstheintaketemperatureduringcoolinganddryoperation.
(Enabledonlywhenthebodythermostatisused.)
IncreasethisvaluewhenitisdifficulttoturnthethermostatON.
18
Automaticstoptimeafter
operationstart
Thetimeatwhichanindoorunitisautomaticallystoppedafteroperation
startscanbesetinincrementsof5minutes.
1b
ForcedthermostatON
time
Usethissettingtochangethetimeforforcedoperationatinstallation
orservicingfrom5minutesto4minutes.
1E
Temperatureshiftfor
cooling/heatingchange
in“autoheat/cool”mode
“Autoheat/cool”selectstheoperatingmodeautomaticallybasedon
thedifferencebetweentheroomtemperatureandthetemperatureset
ontheremotecontroller.Thissettingestablishesashifttemperaturefor
theheating/coolingtemperaturesettingrelativetotheremotecontroller
temperaturesetting.
Cooling temperature setting
Heating temperature setting
Remote controller temperature setting
Shift temperature
Shift temperature
7-6. Detailed Setting Items
Coolingtemperaturesetting
Remotecontrollertemperaturesetting
Heatingtemperaturesetting
Shifttemperature
Shifttemperature
7-11
SM830194-04_Single_BigPAC.indb 11 2014/11/14 14:38:37