1
1-10-1-1-5
How to connect wiring to the terminal
For stranded wiring
(1) Cut the wire end with cutting pliers, then strip the
insulation to expose the stranded wiring about 10 mm
and tightly twist the wire ends.
Stranded wire
Ring
pressure
terminal
Strip 10 mm
(2) Using a Phillips head screwdriver,
(3)
each stripped wire end with a ring pressure terminal.
(4) Place the ring
the removed terminal screw using a
pressure terminal, and replace and tighten
screw(s) on the terminal board.
Using a ring connector fastener or
remove the terminal
pliers, securely clamp
screwdriver.
Ring
Screw and
Special washer
pressure
terminal
Terminal board
Ring pressure
terminal
ScrewSpecial
washer
Wire
Wire
Examples of shield
shield.(1) Remove cable coat not
wires
to scratch braided
wires
twist the carefully and (2) Unbraid the braided shield
covering them with
tightly together.
tape
Insulate the
insulation tube or an
around them.
unbraided shield
shield wires by
wrapping insulating
(3) Remove coat of
Insulating tape
signal wire.
Shield mesh
tape
mesh
Insulating
Shield
(4) Attach ring pressure terminals to the
(2).
the shield wires insulated in Step
signal wires and
SM830283-00_欧州向け R32シングル36-71形TD&SM.indb 5 20/01/30 10:24:57
To Next Page
Loading...
