11 Service Position
11.1. Checking & Repairing Panel
P.C.B.
Step 1 Remove the top cabinet.
Step 2 Remove the DVD lid.
Step 3 Disassemble the front panel.
Step 4 Disassemble the the Panel P.C.B.
Step 5 Disassemble the the Volume P.C.B.
Step 6 Disassemble the USB P.C.B.
Note: Refer to items in Chapter 9 for disassembly procedures
of respective Part & P.C.B.
Step 7 Connect FFC cable at the connectors (CN2005 &
CN2007) on Main P.C.B. and (CN8000) on USB P.C.B.
Step 8 Turn over Panel P.C.B. horizontally and place it
according to the diagram shown below.
11.2. Checking & Repairing Main
P.C.B.
Step 1 Remove the top cabinet.
Step 2 Remove the DVD lid.
Step 3 Disassemble the front panel.
Step 4 Disassemble the Panel P.C.B.
Step 5 Disassemble the Volume P.C.B.
Step 6 Disassemble the USB P.C.B.
Step 7 Disassemble the DVD mechanism unit.
Step 8 Disassemble the USB Relay P.C.B.
Step 9 Disassemble the rear panel.
Step 10 Disassemble the Main P.C.B. & Tuner Extent P.C.B.
Step 11 Disassemble the SMPS Module P.C.B.
Note : Refer to items in Chapter 9 for disassembly procedures
of respective Part and P.C.B.
Step 12 Position Panel P.C.B., Volume P.C.B., USB P.C.B.,
DVD mechanism unit, USB Relay P.C.B., SMPS Module
P.C.B., Main P.C.B. & Tuner Extent P.C.B. according to
diagram shown below.
Step 13 Connect FFC cable at the connectors (CN2001,
CN2005, CN2007 & CN5704) on Main P.C.B., (CS901) on Tray
Loading P.C.B., (CN2 & CN3) on SMPS Module P.C.B.,
(CN8000) on USB P.C.B. and (CN8003) on USB Relay P.C.B.
Step 14 Turn over the Main P.C.B. vertically and place it
according to the diagram.
50
SA-PT160E / SA-PT160EB / SA-PT160EG
To Next Page
Loading...
