RQT8724
37
Using sound effects
You can enhance low-frequency sound so that heavy
bass sound can be heard clearly, even if the acoustics of
your room are not optimal. The unit automatically selects
the most suitable setting according to the type of
playback source.
Press [-H.BASS].
(Settings can be confirmed on the
display or the television screen.)
≥ [DVD-V] [DVD-VR]
H.BASS ON (factory preset)
,------.
H.BASS OFF
≥ When another source is selected
H.BASS OFF (factory preset),------.H.BASS ON
The setting you make is retained, and recalled every time
you play from the same type of source.
Automatically adjusts each speaker to enhance the
surround sound effect of multi-channel audio. When
playing two-channel audio, the audio of the L/R front
speakers is also output through the L/R surround
speakers (audio is not output from the center speaker)
and creates a surround sound effect.
Press and hold [—SRD ENH].
Each time you press and hold the button:
(Settings can be confirmed on the display or
the television screen.)
SRD ENH ON,------.SRD ENH OFF
This is one of the ways to get appropriate surround effects.
Preparation
Press [DVD].
∫ To adjust speaker level during play
[Effective when playing multi-channel audio or when
Dolby Pro Logic II or Sound Field Control (MOVIE,
SPORT or MUSIC) is on.]
1 Press [CH SELECT] to select the speaker.
L
#C #R #RS #LS #SW
^----------------------------------------------}
SW: Subwoofer
≥ You can adjust SW only if the disc includes a
subwoofer channel.
≥ “SW” does not appear on the display and is not
adjustable when “ÎPLII” is lit.
≥ “S” appears on the display when “MOVIE”,
“SPORT” or “MUSIC” is selected with Sound
Field Control (➜ page 36).
In this case, you can adjust both surround
speaker levels at the same time using [3, 4].
S:
`
6dB to
i
6dB
2 Press [3] (increase) or [4] (decrease) to
adjust the speaker level for each speaker.
C, RS, LS, SW: `6dB to i6dB
(L, R: Only the balance is adjustable.)
≥ To adjust the balance of the front speakers,
while “L” or “R” is selected, press [2, 1].
Enhancing the bass sound:
H.BASS
Enhancing the surround sound
effect: Surround Enhancer
MONO
ST
H.BASS
SRD
PGM
HDCD
E.
1
W
e.g. Display
NO
ST
SRD
PGM
HDCD
E.
1
W
e.g. Display
Adjusting the volume of each
speaker: Speaker level adjustments
1
While stopped and no on-screen display is shown
Press and hold [—TEST] to output a test signal.
≥ To stop the test signal, press and hold [—TEST]
again.
L: Front left C: Center R: Front right
RS: Right surround LS: Left surround
≥ There is no output from SW (subwoofer) channel.
2
Press [VOLUME, r] or [s] to set the volume level
normally used for listening.
3
Press [3] (increase) or [4] (decrease) to adjust
the speaker level for each speaker.
≥ Adjust the speaker levels to the same level as the
front speakers.
C, RS, LS: `6dB to i6dB
HT855En.book Page 37 Saturday, March 11, 2006 7:56 PM
To Next Page
Loading...
Need help?
General
