RQT8724
6
Simple Setup
Preparation
≥ To prevent damage or scratches, lay down a soft cloth and perform assembly on it.
≥ For assembly, use a Phillips-head screwdriver.
≥ Make sure you have all the indicated components before starting assembly, setup, and connection.
≥ There is no difference between the right and left speakers and stands.
≥ For optional wall mount, refer to page 41.
1 Attach the stand to the base.
1 Thread the speaker cable through the base.
For quicker threading, loosely fold the cable in
half (do not crease), pass the folded portion
through the hole, and then pull the rest of the
cable through the base.
2 Attach the stand to the base while gently
pulling on the end of the speaker cable.
2 Secure the stand to the base.
3 Attach the speaker to the stand.
1 Pull out the end of the speaker cable and
position it between the ridges.
2 Attach the speaker to the stand.
STEP1 Assembling the front speakers
The supplied stands are specially
designed for attachment to
Panasonic SB-FS540 front
speakers. Use only as indicated in
this setup.
2 Front speakers
(with cover plate)
2 Bases2 Stands
(with cable)
8 Screws
Base
Cable
Stand
Base
Cable
Pull gently.
2
1
Screw
Tighten securely.
Slide the speaker
cable into the
groove.
Stand
Base
Screws
Tighten securely.
Cable
Ridges
Stand
Speaker
Stand
Cover plate
Remove before attaching the
speaker and keep for wall-
mount use (➜ page 41).
Assembling the front speakers
8606En_p06-19.f m Page 6 Thursday, March 16, 2006 10:44 AM
To Next Page
Loading...
Need help?
General
