RQT8724
7
Simple Setup
4 Secure the speaker to the stand.
5 Connect the speaker cable.
∫ Preventing the speakers from falling
≥ You will need to obtain the appropriate screw
eyes to match the walls or pillars to which they
are going to be fastened.
≥ Consult a qualified housing contractor concerning
the appropriate procedure when attaching to a
concrete wall or a surface that may not have
strong enough support. Improper attachment may
result in damage to the wall or speakers.
Speaker
Stand
Screw
Tighten securely.
Ensure the speaker cable
is centered in the groove.
_: White
`: Blue
Push!
Press the speaker
cable into the groove.
Insert the wire fully.
Assembled!
String (not included)
Thread from the wall to the
speaker and tie tightly.
Rear of the speaker
Wall
Approx. 150 mm
Screw eye
(not included)
Assembling the front speakers
HT855En.book Page 7 Saturday, March 11, 2006 7:56 PM
To Next Page
Loading...
