RQT8724
42
Speaker installation options
Speaker installation options
Reattaching the speaker cable to the stand
1
Remove the eight screws from the stand, and remove the speaker net.
2 Position the cable.
3 Attach the speaker net with the screws.
∫ Fitting speaker stands (not included)
(Except front speakers)
Ensure the stands meet these conditions before purchasing them.
Note the diameter and length of the screws and the distance between screws as shown in the diagram.
≥ The stands must be able to support over 10 kg.
≥The stands must be stable even if the speakers are in a high position.
Screw
Press the cable into
the groove.
Approx. 15 cm
Cable
Speaker stand
(not included)
Plate thickness
plus 7 mm to 10 mm
e.g. Center speaker
5 mm, pitch 0.8 mm
Metal screw holes
For attaching to
speaker stands
60 mm
8606En_p34-52.f m Page 42 Thursday, March 16, 2006 2:00 PM
To Next Page
Loading...
