Step 1 Detach the head block connector (Deck P.C.B.).
Step 2 Desolder wire(W1002) at motor assembly.
Step 3 Remove Deck P.C.B.
Step 4 Remove 3 screws (for deck 1 & 2).
Step 1 Release the catch, and then remove the pinch roller (F).
Step 2 Release 2 claws and detach the head block connector.
Step 3 Remove 2 screws.
Step 4 Remove head block.
Step 5 Remove capstan belt A/B.
Step 6 Remove the flywheel R.
Step 7 Release the claw and remove the winding lever and
spring.
[Installation of the belt]
Step 1 The boss and marking should be positioned
horizontally.
11.18.2. Disassembly of capstan motor ass’y, capstan belt A, capstan belt B and winding
belt
SA-VK950GC / SA-VK950GS / SA-VK950GCS / SA-VK950GC
To Next Page
Loading...
