7. Disconnect the connector. (C23)
8. Remove the screws (×5
) and remove the C2-Board.
6.19. Remove the stand brackets
1. Remove the plasma panel section from the servicing stand
and lay on a flat surface such as a table (covered) with the
plasma panel surface facing downward.
2. Remove the stand brackets (left, right) fastening screws (×3
,×1 each) and remove the stand brackets (left,
right).
6.20. Remove the C3-Board
1. Remove the stand bracket left. (See section 6.19.)
2. Remove the screws (×2
) and remove the mounting
metal D.
3. Remove the flexible cables holder fastening screws (×14
).
4. Disconnect the flexible cables (CB9, CB10, CB11, CB12,
CB13, CB14 and CB15).
5. Disconnect the flexible cable (C30 and C32).
6. Disconnect the connectors (C33 and C35).
7. Remove the screws (×5
) and remove the C3-Board.
6.21. Remove the C4-Board
1. Remove the stand bracket right. (See section 6.19.)
2. Remove the screws (×2
) and remove the mounting
metal D.
16
TH-42PZ70B / TH-42PZ70E / TH-42PY70F / TH-42PY70P
To Next Page
Loading...
