Why does my Panasonic Lcd dislpay power off automatically?
Your Panasonic Lcd dislpay might be turning off unexpectedly because of certain power-saving settings. Check the settings for “No Signal power off”, “PC Power management”, “DVI-D Power management”, and “No activity power off”. Ensure that none of these are set to “On (Enable)”.
What to do if my Panasonic Lcd dislpay LAN is uncontrollable?
If the LAN is uncontrollable on your Panasonic Lcd dislpay, verify that the connection has been properly established. Ensure that “Control I/F Select” is set to “LAN” when using WEB browser control or command control. Also, check that “LAN Setup” is configured correctly. If connecting to an AMX or Crestron Electronics, Inc. device, configure “AMX D.D.” or “Crestron Connected™” according to the device you are using.
How to fix uncontrollable RS-232C on Panasonic Lcd dislpay?
If the RS-232C on your Panasonic Lcd dislpay is uncontrollable, first check that the connection is properly made. When controlling the RS-232C command from the RS-232C terminal on the display, ensure that “Control I/F Select” is set to “RS-232C”.
What to do if there is no picture or sound on my Panasonic Lcd dislpay?
If your Panasonic Lcd dislpay sometimes shows no picture or has no sound, try turning the power off and on again. Alternatively, consider replacing the selector or distributor.
General| Screen Size | 50 inches |
|---|---|
| Panel Type | IPS |
| Resolution | 1920 x 1080 |
| Aspect Ratio | 16:9 |
| Display Type | LCD |
| Brightness | 350 cd/m² |
| Viewing Angle | 178°/178° |
| Response Time | 8 ms |
| Built-in Speakers | Yes |
| Input Ports | HDMI, VGA, DVI |
| External Control Terminals | RS-232C, LAN |
To Next Page