Panasonic TH-55AF1U - [LAN Control] application; Network Control and Protocol Settings

54
[LAN Control] application
This unit unique application. Select the [LAN Control] button icon on the [TOOLS] screen to display the [LAN Control]
screen.
Sets [ON]/[OFF] of [Command Control], [Control Protocol], [Port number], [Display name], [User name] and [Password]
via LAN of this unit.
■ [Command Control]
Set this to [ON] when performing the command control of this unit (see page 98) via network.
[ON]: Enables the command control.
[OFF]: Disables the command control.
■ [Control Protocol]
Select the protocol for the LAN control.
[Protocol1]: Controls with the sequence of the Panasonic display.
[Protocol2]: Controls with the sequence compatible with the Panasonic projector.
Note
●
PJLink can be operated regardless of the [Control Protocol] setting.
●
When performing the command control with TCP/IP, select [Protocol1].
●
When operating the “Early Warning Software” or “Multi Monitoring & Control Software”, select [Protocol2].
■ [Port number]
Set the port number to use for the command control.
Setting range: 1024 (Default) to 65535 (excluding 4352)
Note
●
When using PJLink, the port setting is not necessary.
■ [Display name]
Set the name of this unit displayed on the network.
■ [User name]
Set the user name added to the command.
(Default: admin1)
■ [Password]
Set the password used for the command control and PJLink security authentication.
(Default: panasonic)