Panasonic TH-55VF2W - Page 78

English
78
Controller user level
Limits operation of the buttons on the remote control.
[Off]:
You can use all of the buttons on the remote control.
[User1]:
You can only use <POWER ON>, <STANDBY>,
<INPUT>, <RECALL>, <MUTE>, <VOL +> and
<VOL -> buttons on the remote control.
[User2]:
You can only use <POWER ON> and <STANDBY>
buttons on the remote control.
[User3]:
Locks all the buttons on the remote control.
Note
●
About how to reset the settings to defaults:
“Initialization” (see page 80)
PC auto setting
Sets the operational mode of the automatic position
adjustment in the [Position] menu.
[Off]:
Automatic position adjustment starts when <AUTO
SETUP> is pressed on the remote control or
automatic position adjustment is executed from the
[Position] menu.
[On]:
Other than remote control or menu operation,
automatic position adjustment starts:
•
When the display power is turned ON.
•
When the input signal is switched.
Off-timer function
Enables / disables Off timer function.
[Enable]:
Enables the [Off-timer function].
[Disable]:
Disables the [Off-timer function].
Note
●
When [Disable] is set, the Off-timer is cancelled.
Initial startup
Sets the power mode of the unit for when the power
recovers from failure or after plugging off and in again.
[Last memory]:
Power returns in as the same state as before the
power interruption.
[On]:
Power returns in power On.
(Power Indicator: green)
[Standby]:
Power returns in standby mode.
(Power Indicator: red/orange)
Note
●
When using multiple displays, [Standby] is preferred
to be set in order to reduce a power load.
Clock display
Sets to display / hide the clock.
[Off]:
Hides the clock.
[On]:
Displays the clock.
Note
●
The clock is displayed at the lower left of the screen
when <RECALL> button is pressed.
●
When [Date and time] is not set, the clock is not
displayed even when [Clock display] is [On]. (see
page 67)
Power on message(No activity power
off)
Sets to show/hide [No activity power off] precautions
when the power is turned on.
[On]:
The warning precautions are shown when the
power is turned on.
[Off]:
The warning precautions are not shown when the
power is turned on.
Note
●
This setting is enabled only when [No activity power
off] is [Enable] (see page 66).