When repeaters are used:
9.2.1 Registering repeaters
1 Main monitor:
M N ®
select “Register/Cancel” ®
.
2 Select “Register” ®
.
R If
you are prompted to register your main monitor,
select “Main monitor” ®
.
3 Select “Repeater” ® .
4 Select the number of the repeater to be registered
®
.
R Complete
the following operations within about 2
minutes.
5 Repeater:
While the power is on, press and hold
MPROGRAMN (A) for about 3 seconds.
R The STATUS indicator (B) flashes in green.
R After completing the registration, the indicator
lights up solid.
S
TA
TUS
IN
USE
(LE
D)
PRO
G
RAM
PROGRAM
A
B
6 Main monitor:
Press M N.
Note:
R If you register two repeaters, please separate them
more than 3 meters to avoid electrical noise.
R When using devices in separate buildings or over
long distances, cut outs and image distortions may
not be improved even if a repeater is used.
9.3 Cancelling devices (main
monitor/extension monitor)
1 M
N ® select “Register/Cancel” ® .
2 Select “Cancel” ® .
3 Select the type of device to cancel
*1
®
.
4 Select the device to cancel
*1
®
*1
®
.
R A beep sounds and “Cancel completed” is
displayed.
*1
Not displayed when using as an extension monitor.
Important:
R To prevent incorrect operations, remove the
batteries from cancelled sub monitors.
Note:
R When you want to change an extension monitor's
registration number or re-register an extension
monitor, first use the extension monitor to cancel
itself, and then re-register it again as an extension
monitor. (Extension monitors become main monitors
again when they are cancelled.)
28
9. Expanding the system
To Next Page
Loading...
