6. Secure
the lobby station to the flush mount box using the 4 supplied screws. Use the supplied hex wrench to fasten
the screws.
Note:
R Do not cover the water drain holes.
Registering the lobby station
Perform this procedure once for each lobby station after it is connected to the control box.
1. Press any number key.
2. Press M N.
R The lobby station is registered in the system.
R If an error is displayed, the lobby station will still be registered to the system.
4.4 Installing the Control Box/Distribution Box/Lift Controller/
Extension Box
The following 2 methods can be used for installation.
–
mounting on a DIN rail
– attaching directly to a wall
Note:
R Keep the control box away from electrical noise generating devices, such as fluorescent lamps and motors.
R Do not remove the dust cover covering the control box’s USB port (page 13) during installation, and make sure it
completely covers the USB port to prevent any debris from falling into the USB port.
24
4. Installation
To Next Page
Loading...
