4.7 Basic settings
The
following is a list of basic settings we recommend that you configure before using the system. Most items can be
configured using PC programming, but other programming methods may be available. See the programming chapter
(page 39) for details.
R For the control box
– Date and time
Configure using PC programming (5.2.7 Setting the control box’s date and time (Page 42))
– Room number and other information for each room
Configure using PC programming (Control Box — Room settings (Page 42))
– General system settings
Configure using PC programming (Control Box — General settings (Page 43))
R For lobby stations
– General settings stored in each lobby station
Configure using PC programming (Lobby Station 1–3 — General settings (Page 44))
– Room number and name stored in each lobby station
Configure using PC programming (Lobby Station 1–3 — Room settings (Page 44))
R For distribution boxes
– DIP switch settings
Configure using the device’s DIP switches (4.5.4 Distribution box switch settings (Page 32))
R For lift controllers
– DIP switch settings
Configure using the device’s DIP switches (4.5.5 Lift controller DIP switch settings (Page 35))
– Lift access permissions for each room
Configure using PC programming (Control Box — Room settings (Page 42))
– Confirming the connection
Perform using the setup tool (5.2.9 Confirming the control box’s connection to the lift controllers (Page 42))
R For main monitors
– Room number and other information for each room
We recommend using PC programming for initial setup (Control Box — Room settings (Page 42). You can
change these settings on a room by room basis using main monitor programming if necessary (5.5 Main
monitor programming (Page 50)).
– Applying room settings to the main monitors
Perform using the setup tool (5.2.8 Configuring the main monitors (Page 42))
R For electric locks and access controllers
– Door open times, codes, signals types, and various other settings
Configure using PC programming (Lobby Station 1–3 — General settings (Page 44))
R For terminals
– Extension numbers, terminal names, and various other settings
Configure using PC programming (Control Box — General settings (Page 43))
38
4. Installation
To Next Page
Loading...
