Panasonic VL-V900 - Lobby Station Programming

Parameter Description and available settings Default
Camera Name Determines the camera name.
[1]: CAMERA #
[2]: RECEPTION
[3]: GATE
[4]: CONTROL ROOM
[5]: RESTAURANT
[6]: HALL
[7]: POOL
[8]: SECURITY OFFICE
[9]: ENTRANCE
[10]: GYM
[11]: GUEST ROOM
[12]: KID’S ROOM
[13]: PARKING
[14]: TERRACE
[15]: LIFT LOBBY
1
(CAMERA #)
Camera Display Priority Determines which camera image is displayed when
monitoring begins.
[0]: LOBBY
[1]: CAMERA
[2]: CAMERA ONLY
0
(LOBBY)
Camera Switching Image Determines whether visitors (lobby station users) can
switch between the lobby station camera and the
external camera.
[0]: NO
[1]: YES
0
(NO)
Wide/Zoom Determines whether camera images are displayed in
wide mode or in zoom mode when monitoring begins.
[0]: WIDE
[1]: ZOOM
0
(WIDE)
Zoom Position Determines the camera zoom position.
[1]: UPPER LEFT
[2]: UPPER SIDE
[3]: UPPER RIGHT
[4]: LEFT
[5]: CENTRE
[6]: RIGHT
[7]: LOWER LEFT
[8]: LOWER SIDE
[9]: LOWER RIGHT
5
(CENTRE)
Power Frequency Tells the system what frequency of power is supplied
to the lobby station.
[0]: 50 HZ
[1]: 60 HZ
0
(50 HZ)
Access Code Determines the access code that allows you to use
lobby stations to configure the system.
(6 digits)
123456
5.3 Lobby station programming
You can use a lobby station to configure various system settings.
1 Register the lobby station
(page 24).
R If you have already registered the lobby station, skip this step.
45
5. Programming