3. When the display lights up, release all the buttons.
4. Use the navigator key to select “Apartment mode” ®
.
R The main monitor initialises its settings.
R While performing the next steps, you can cancel without saving your settings by pressing M
N.
5. Enter the room number.
a. Use the navigator key to select the desired number.
b. Use the navigator key to accept the entered number and advance the cursor.
c. Press when finished.
6. Enter the floor number.
a. Use the navigator key to select the desired number.
b. Press when finished.
7. Set the visitor lift permissions for “Lift 1”.
a. Use the navigator key to allow or prohibit lift usage for visitors to each lobby.
b. Use the navigator key to select the next lobby station.
c. Press
when finished.
R Repeat the above procedure for “Lift 2” and “Lift 3”.
8. Confirm the displayed settings.
R Press
to go back and enter the desired settings again.
9. Press to check for a duplicate room number.
R If a duplicate room number is found, press to overwrite the existing room number settings, or
to cancel saving the settings.
If no duplicate is found, the settings are saved in the control box.
Note:
R If
you press
, the settings will be saved in the main monitor only, and the main monitor will restart. To save
the settings in the control box, press
.
When programming the VL-MW251
1. Press and hold MOFFN, MTALKN, and MMENUN at the same time (3 buttons total).
R Continue to hold the buttons and perform the next step.
2. Press and hold the MRESETN button for about 3 seconds, then release the MRESETN button only.
R The main monitor starts up and enters programming mode.
3. When the display lights up, release all the buttons.
4. Press the
or soft keys to select “APARTMENT MODE” ® .
R The main monitor initialises its settings.
R While performing the next steps, you can cancel without saving your settings by pressing MOFFN.
5. Enter the room number.
a. Press or to select the desired number.
b. Press to accept the entered number and advance the cursor.
c. Press when finished.
6. Enter the floor number.
a. Press or to select the desired number.
b. Press when finished.
7. Set the visitor lift permissions for “LIFT 1”.
a. Press or to allow or prohibit lift usage for visitors to each lobby.
b. Press to select the next lobby station.
c. Press when finished.
R Repeat the above procedure for “LIFT 2” and “LIFT 3”.
8. Confirm the displayed settings.
R Press to go back and enter the desired settings again.
51
5. Programming
To Next Page
Loading...
