Panasonic WJ-ND400K

40
Turn on/off the power of the recorder
■ Turn on the power of the
recorder
Turn on the power of the recorder.
1 Insert the power plug into an outlet.
120 V AC 60 Hz, for the NTSC model
220 V to 240 V AC 50 Hz, for the PAL model
Use the power source that is suited to your model.
2 Press the POWER switch at the rear of the recorder
to turn on the power.
 • The[OPERATE]indicatorwilllightandthesystemcheck
(checking the system and hard disk drives) will start.
 • The"WJ-ND400"indicationwillbedisplayedontheLCD
at startup, and the "Initializing" indication will be displayed
during startup.
The "Initializing" indicatior will turn to "Don't turn off" after a
short time.
 • Whenthesystemcheckiscomplete,thetimeanddate
display (standby display) will be displayed on the LCD.
(Page 41)
Important:
 • Donotturnoffthepowerduringthepoweronprocess.
 • Whenusingtheextensionunits(WJ-HDE400),turnonthe
power of the recorder after turning on the power of all the
extension units.
■ Turn off the power of the
recorder
To shutdown the recorder, do the following.
Important:
 • Removetheplugfromtheoutletifnotoperatingthe
recorder not in use long.
 • Whentherecorderhasnotbeenusedforacertainperiod,
turn on the power of the recorder (approximately once a
week) and perform recording/playback to prevent interfer-
ences with functions.
● During recording
1 Select "Off" for "Recording" under "Basic" on the
setup menu to stop all recordings. (Refer to the
setup instructions (PDF).)
2 Turn off the power of the recorder after confirming
that all the HDD access indicators are off.
The [OPERATE] indicator will go off.
Note:
 • Afterturningonthepoweroftherecorderagain,donot
forget to set the "Recording" setting under "Basic" to "On".
● During playback
1 Click the [STOP] button on the [HDD] tab on the
operation window. (Refer to the operating instruc-
tions (PDF).)
2 Turn off the power of the recorder after confirming
that all the HDD access indicators are off.
The [OPERATE] indicator will go off.