Panasonic WJ-ND400K

To Next Page

To Previous Page

■ Reboot

When pressing the [SET] button while the "Manual Reboot" indication is being displayed, the "ACCEPT" indication will be displayed.

Select "YES", and then press the [SET] button. The recorder will be rebooted.

[SET]

Main Page

Limitation of Liability3
Disclaimer of Warranty3
Important Safety Instructions4
Table of Contents5
Preface6
About the User Manuals6
System Requirements for a PC7
Trademarks and Registered Trademarks7
Gpl/Lgpl8
Copyright8
Network Security8
Precautions9
Precautions for Installation11
Major Operating Controls and Their Functions12
- Front View12
- Inside the14
- Rear View16
  - Power Cord Plug Brace16
Outline of Functions17
- HDD (Hard Disk Drive)17
- Recording/Playback18
- Network20
Operations Flow23
Install the Recorder in a Rack24
- Installation Procedure24
- Position in the Rack25
Connections26
- Connection between Cameras and Pcs26
About the Connectors33
- How to Use the Terminals of the ALARM/CONTROL Connector33
- How to Use the Terminals of the ALARM Connector37
  - Pin Configuration37
  - Alarm Connection38
- Time and Polarities of the ALARM/CONTROL Terminal and the ALARM Terminal39
Turn On/Off the Power of the Recorder40
- Turn on the Power of the Recorder40
- Turn off the Power of the Recorder40
  - During Recording40
  - During Playback40
Operations Using the Buttons on the Front Panel41
- Basic Operations41
- Check the System Information42
- Check the IP Address43
- Set the IP Address44
  - How to Configure the Settings for each Item44
- Enable/Disable the Key Lock44
- HDD Unit45
- Handle the Hard Disk Drives46
- Data Recovery (in the RAID 5/RAID 6 Mode)54
  - Replacement of a Faulty Hard Disk Drive in the RAID Mode55
- Reboot56
Troubleshooting57
Specifications60
Standard Accessories61
Index62

Panasonic WJ-ND400K

Table of Contents

Other manuals for Panasonic WJ-ND400K

Related product manuals