Panasonic WJ-ND400K

47
● Install the HDD units
It is possible to install the HDD units without stopping the
operation.
1 After inserting the provided key into the key hole on
the front cover, push and turn it to the right to open
the front cover.
Note:
 • ThecushionbetweenthefrontpanelandHDDcanisteris
used for protection at transportation.
Remove this cushion before use.
When transporting the recorder, provide the cushion
between the front panel and HDD canister.
2 Insert the HDD units into the HDD slots in order
starting from HDD1.
Lift the lever on the HDD unit while holding down the
removal knob, and then insert the HDD unit all the way into
the HDD slot.
(1) Pinch the tab on the HDD slot with the hook on the
HDD unit securely.
(2) Press the lever down and push it until the removal
knob clicks.
3 Recognition process of the hard disk drive will start
automatically.
 • TheHDDstatusindicatorwillblinkorangeduringtherec-
ognition process.
When the recognition process is complete, the HDD status
indicator will light or blink green.
 • Whentheinsertedharddiskdriveisunformatted,format-
ting will start automatically.
When formatting is complete, the HDD status indicator will
light green.
 • Whentheinsertedharddiskdriveisformatted,itwillbe
recognized as the hard disk drive for playback use only. In
this case, the HDD status indicator will blink green. To use
it for recording, follow the instructions from step 4.
Note:
 • TheHDDstatusindicatorsometimesmaylightgreen
before blinking orange when a hard disk drive is inserted.
4 Hold down the [USE] button for 2 seconds or more.
The buzzer will sound.
5 Press the arrow button (up or down) repeatedly until
the "HDD Operation" indication is displayed.
(1)
(1)
(2)
(1)
(2)
Cush ion