Panasonic WJ-ND400K - Page 53

53
3 After inserting the provided key into the key hole on
the front cover, push and turn it to the right to open
the front cover.
4 Determine the operational mode using the [RAID]
switch.
S: Single mode (Default)
R5: RAID 5 mode
R6: RAID 6 mode
5 Turn on the power of the recorder by pressing the
[POWER] switch while holding down the [USE] but-
ton until the buzzer starts sounding.
The recorder will start up in the selected operational mode.
Important:
 • Donotchangetheoperationalmodeafterstartingthesys-
tem operation. If the operational mode is changed after
starting the system operation, reading of the recorded data
may fail.
[USE] button
[RAID] switch
(1)
(2)