21
Getting To Know
Your Machine
• Select and continue pressing the appropriate key on the keypad until the desired Character / Symbol is displayed,
then select another key on the keypad to enter the next Characters / Symbols. If the next Character / Symbol that
you wish to enter falls on the same key, press
, to set the first Character / Symbol before continuing.
Press
SET
to complete the registration.
Ex: To input an "o" and "n", the
6
key is used for both Characters.
Enter as follows:
6
x 4
6
x 3
SET
• To delete a Character / Symbol, press
CLEAR
.
• To enter a space, press
MONITOR
.
• Upper case characters are typically used to enter Station Name, etc. Lower case characters are typically used to
enter E-mail Addresses.
Character Table and Required Number of Key Strokes
1234567891011121314
1 @ . Å å Ä ä Ö ö Ü ü È è É é Æ æ Ñ
1 @ .
2abcABC
3de fDEF
4gh iGHI
5jklJKL
6mnoMNO
7pqrsPQRS
8tuvTUV
9wxyzWXYZ
0 - / ( ) _ , ’ : % & + =
0 - / ( ) _ ’ : & + = ! " $ < > % ? [ ] ^ ` { | }
To Next Page
Loading...
Need help?
General
