AUTO : This setting, by moving the shutter automatical-
ly when necessary, provides a clearer picture
ofextremelybrightobjectsoutdoors,etc.
OFF :
Fixedat1/50seconds.
ThefactorydefaultsettingisAUTO.
Notes:
•When AUTO is selected for the shutter setting,
fluorescent lighting may cause flickering of the
picture.Ifthishappens,selectOFFfortheshutter
speed setting.
•AUTO is disabled when MANUAL is selected for
lightcontrol(ALC/MANUAL)andFIXisselectedfor
electronicsensitivityenhancement(SENSUP).
4 Gain Control (AGC)
1. Move the cursor to AGC, and then tilt the joystick
left or right to select a gain control setting.
ON (LOW) : Low gain
ON (MID) : Medium gain. This is the factory default
setting.
ON (HIGH) : High gain
OFF : Does not increase the gain
Note:
•When AGC is turned on, the noise reduction
function automatically activates under low
illumination to reduce digital noise. This also,
however, can cause afterimages to be generated
by moving objects, and by panning and tilting the
camera. For more information, see the DNR
setting(page11).
5 Electronic Sensitivity Enhancement (SENS UP)
1. Move the cursor to SENS UP, and then tilt the
joystick left or right to select an electronic sensitivity
enhancement setting.
The electronic sensitivity enhancement setting can
bechangedonlywhenOFForAUTOisselectedfor
the shutter speed (SHUTTER) setting. Tilting the
joystick cycles through the settings display in the
sequence shown below.
When SUPER-D6 is turned off
When setting MANUAL of ALC/MANUAL
When SUPER-D6 is turned on
ThefactorydefaultsettingisOFF.
Use the following steps to perform masking
(1) Tilt thejoystickupanddown, andleftandright
to move the cursor to a cell you want to mask.
(2) PresstheCAM(SET)buttontomaskthecell.
Moving the cursor to a cell that is already
masked causes the blinking pattern of the
cursor to alternate between horizontal stripes
and white.
PressingtheCAM(SET)buttonwhilethecursor
is located at a masked cell cancels the masking
of the cell.
To cancel all masking areas, press the F3
button.
(3) Aftermaskingallofthecellsyouwant,pressthe
MON (ESC) button to return to the ALC CONT
menu in step 1.
6. Move the cursor to LEVEL, and then tilt the joystick
left and right to adjust the picture output level
(picturecontrast).
IfyouselectedONinstep3ofthisprocedure,best
results can be obtained by setting a contrast level
that is somewhat high. A contrast level that is too
high, however, may increase the tendency of
afterimages and noise.
3 Shutter Speed (SHUTTER)
1. Move the cursor to SHUTTER, and then tilt the
joystick left or right to select a shutter speed
setting.
Tilting the joystick cycles through the shutter speed
settings display in the sequence shown below.
When SUPER-D6 is turned off
When setting MANUAL of ALC/MANUAL
When SUPER-D6 is turned on
To Next Page
Loading...
