3. Use the joystick to move the cursor the character you
wanttoinput,andthenpresstheCAM(SET)button.
The text input procedure is the same as that for
camera ID input.
See steps 3 through 5 under “Camera ID Settings”
onpage5forinformationaboutinputtingthetextfor
the preset ID and specifying its position on the
display.
To copy the preset ID of another position number
MovethecursortoCOPY,andthenpresstheCAM
(SET) button. This displays the preset ID of the
position number preceding the one you are
currentlyconfiguring.EachpressoftheCAM(SET)
button scrolls back to the next sequential position
number and displays its preset ID.
Notes:
•WhensettingthepresetID,thecameraIDwillbe
displayed above the preset ID. The preset ID
position has priority over other positions.
•Whether the camera ID is set to Open or Close,
camera ID will be displayed.
Whether or not the camera ID is set, when preset
ID is displayed, the camera ID will also be
displayed, but this only applies within the present
channel.
n Language Setting
1. MovethecursortoLANGUAGE , and then press
theCAM(SET)button.
2. On the 8-language selection menu that appears,
select the language you want to use.
The factory default setting is English.
*All of the example screens in these Operating
Instructions show English display messages.
3. Move the cursor to SET, and then press the CAM
(SET)button.
*The item that was set flashes when the language is
being changed and stops flashing when the
language has been changed. Do not operate the
system controller when changing settings.
*The “LANGUAGE” display remains in English even
when the language setting is changed.
n Advanced Menu Settings
The advanced setup menu can be displayed from the
setup menu.
1. Displaythesetupmenu(page5),movethecursor
to →ADVANCEDSETUP, and thenpressthe CAM
(SET)button.
This will display the advanced setup menu.
ALL items can be set on the advanced setup menu.
To switch back to the quick setup menu from the
detailed menu, move the cursor to →QUICK SET
UP,andthenpresstheCAM(SET)button.
Refer to the pages below for details of setup menu
items.
1 CAMERA Camera settings Page 9
2 PAN/TILT Pan/tiltsettings Page14
3 ALARM Alarm settings Page 22
4 SPECIAL Special settings Page 25
5 COMMUNICATION* RS485setup Page4
6 SCENESELECT Sceneselectsettings
Page 6
7 LANGUAGE Languagesetting
This page
8 QUICK SETUP About the setup menus
Page 5
9 PASSWORDLOCK Passwordsettings
Page 27
* This item appears only when RS485 settings are
configured with the DIP switches.
To Next Page
Loading...
