Panasonic WV-CW590G

9
Camera settings
n Using the Camera Setup Menu
Display the camera setup menu from the setup
menu (Advanced Menu) to configure camera
settings(page8).
1. Display the advanced setup menu (page 8) , move
the cursor to CAMERA
, and then press the CAM
(SET)button.
This will display the camera setup menu.
 * The following sections numbered 1 to A explain
how to use each of the camera setup menu items.
1 Camera ID (CAMERA ID)
See page 5 for information on the camera ID
settingsmethod.ThefactorydefaultsettingisOFF.
2 Light Control (ALC/MANUAL)
1. MovethecursortoALC/MANUAL,andthentiltthe
joystick left or right to toggle between ALC and
MANUAL.
ALC : Enables automatic lens iris adjustment in
accordance with subject brightness.
Select this ALC when using SUPER-D6.
This is the factory default setting.
MANUAL : Adjust the lens iris with the IRIS button on
the system controller.
    Fixesthelensiris.
2. IfALCissetinstep1,presstheCAM(SET)button
to set SUPER-D6.
SUPER-D6 (Super Dynamic 6)
When there is wide variation between the illumination of
light and dark areas of the location being monitored,
the camera adjusts the lens iris in accordance with the
bright areas. This causes loss of detail in dark areas.
Conversely, adjusting lens brightness for the dark
areas cause brighter area to become washed out.
SUPER-D6 digitally combines an image that is set up
for a clear view of bright areas with an image that is set
up for a clear view of dark areas, creating a final image
that preserves overall detail.
Notes:
•SUPER-D6 is supported only when ALC is
selectedforlightcontrol(ALC/MANUAL).
•Camerasettingsarelimitedtothefollowingwhen
SUPER-D6 is turned on.
SHUTTER :OFF,AUTO(page10)
SENS UP :OFF,AUTO(page10)
•If lightingconditions cause eitherof the following
phenomena, turn off SUPER-D6.
 (1) Screenflickeringorabnormalcolor
 (2) Digitalnoiseinthebrightareasofthescreen
3. Move the cursor to SUPER-D6, and then tilt the
joystickleftorrighttotogglebetweenONandOFF.
ON : Turns on SUPER-D6.(GotoStep6)
OFF : Turns off SUPER-D6.(GotoStep4)
This is the factory default setting.
4. Move the cursor to MASK SET
, and then press
theCAM(SET)button.
This will display the mask area screen, with the
cursor in the upper left cell.
5. Mask the cells in the area where background
lighting is bright. Masking an area will cause its
brightness level to be ignored.
**CAMERA SETUP** 1/2
CAMERA ID OFF
ALC/MANUAL ALC
SHUTTER AUTO
AGC ON(MID)
SENS UP OFF
WHITE BAL ATW1
DNR LOW
BW MODE
AF MODE AUTO L
1
3
5
4
**CAMERA SETUP** 2/2
ZOOM LIMIT X36
STABILIZER OFF
RET TOP
0
A
9
8
6
7
2
Loss of detail
in dark areas
Wash out of
bright areas
Tw o images
digitally combined
to create a clear
final image
**ALC CONT**
BACK LIGHT COMP
SUPER-D6
MASK SET
LEVEL
RET TOP
OFF
•I•••••0
- +