Panasonic WV-CW590G

25
Special settings
n Using the Special Setup Menu
Display the special setup menu from the setup menu to
adjust picture quality.
First,displaythespecialsetupmenu.
1. Display the advanced setup menu (page 8), move
the cursor to SPECIAL
, and then press the CAM
(SET)button.
This will display the special setup menu.
* This section explains items 1 through 5 on the
special setup menu in that order.
1 Adjusting Picture Quality
Use the following procedure to adjust picture quality.
1. MovethecursortoCHROMAGAIN,andthentiltthe
joystick left or right to adjust the CHROMA GAIN
level.
2. Move the cursor to AP GAIN, and then tilt the
joystick left or right to adjust the aperture level.
3. Move the cursor to PEDESTAL, and then tilt the
joystick left or right to adjust the PEDESTAL level.
2 Setting the display (DISPLAY)
1. Move the cursor to DISPLAY, and then tilt the joystick
left or right to select a display setting.
OFF :Pan, tilt, zoom position displays and
alarm are not displayed.
ALL :Pan, tilt, zoom position displays and
alarm are all displayed.
POSITION :Only pan, tilt and zoom aredisplayed.
Alarm is not displayed.
ALARM :Only alarm is displayed. Pan, tilt and
zoompositionsarenotdisplayed.
The factory default setting is ALARM.
The names and types of displays for the alarm display
are shown in the table below.
Notes:
•Use a shortcut (page 29) to switch between
displaying or not displaying the pan, tilt, zoom
positions(duringpan,tiltandzoomoperation)and
type of alarm on the monitor screen.
*The tilt position is displayed ranging from -5
° to
90
° to -5°
3 Compensating for Blemishes (PIX OFF)
1. MovethecursortoPIXOFF
, and then press the
CAM(SET)button.
  This will display the PIX OFF menu. Perform the
following steps to perform blemish compensation
onthepixels.
2. Select a position that has a blemish with the PIX
OFFnumber,andthenpresstheCAM(SET)button.
This will display the blemish compensation pattern
setting screen.
 (1) Usethejoysticktomovethecrosscursor(
)to
thelocationofthedefectivepixels.
 (2) Move the cursor around the display until there
arenomorewhitespots(blemishes)visible,and
thenpresstheCAM(SET)button.
This will store the blemish compensation pattern.
**SPECIAL SETUP**
CHROMA GAIN
AP GAIN
PEDESTAL
DISPLAY
ALARM
PIX OFF
REFRESH → PUSH SET
CAMERA RESET → PUSH SET
SER.NO. BFB03964
RET TOP
••••I••160
••I•••• 22
•I••••• 16
- +
2
4
1
3
5
360°/ 90°/X001
Pan position
Tilt position*
Zoom ratio
Type of alarm
MOTION DET
 Nameofdisplay Typeofalarm
 MOTIONDET MOTIONDET
 SCENECHANGE SCENECHANGE
 ALARMIN1 ALARMIN1
 ALARMIN2 ALARMIN2
 ALARMIN3 ALARMIN3
 ALARMIN4 ALARMIN4